헤비 듀티 선반

4 Stück Kragarmregal-Ständer einseitig Höhe 4,16 m / Tiefe 1,2 m / Länge 4 m

Used cantilever racking: Screw system in hot-dip galvanized design

Scope of delivery:
4 shelf uprights Height 4,160 mm with base section 1,200 mm usable depth
12 cantilever arms with 1,200 mm usable depth, standard
Longitudinal and diagonal braces for 4,000 mm shelf length (spacing 1,300 mm)
Fastening material (screws, nuts and washers)

- (*Delivery time approx. 1 week)
- (*No damaged parts!)
- (*Replacement parts can be reordered and extended at any time)
- (*Offer available in larger quantities: approx. 90 stands in stock)

Detailed description:
- Sturdy steel construction made of IPE profiles (screw system)
- Hot-dip galvanized surface
- Shelf height 4,160 mm
- Load capacity per upright 2,250 kg
- Base section and cantilever arms with 1,200 mm usable depth
- Cantilever arms height-adjustable in 100 mm increments
- 3 screw-on cantilever arms per upright, standard (= 4 storage levels)
- Load capacity per cantilever arm 750 kg
- Including longitudinal and diagonal bracing for 1,300 mm spacing
- Shelf length = 4,000 mm
- Including fixing material (without floor anchors)
- With assembly instructions and load plates C4 according to DIN standard

- Expert advice by telephone
- Made in Germany
- Short delivery time
- On-site collection possible

Our cantilever racks are produced exclusively in Germany.
We offer reliable freight with notification prior to delivery.
The material is sensibly packed to enable easy unloading.

For outdoor installation, the load-bearing capacity is reduced by the wind and snow load.
Guedsfdkb Tepfx Agdek
The base must be concrete, level and suitable for dowels and be able to bear the loads. The customer must check and ensure that the ground conditions and load-bearing capacity as well as any official approvals that may be required.

The shelf stands must be anchored to the floor on site; anchoring to the wall is not necessary and not recommended.
According to the employers' liability insurance association, it is recommended that the uprights on the uppermost storage level protrude at least 500 mm from the top edge of the uprights.

이 광고는 자동으로 번역되었습니다. 번역 오류가 있을 수 있습니다.