Multi-spindle drilling machine

Homag Drillteq H-600

1. BASIC MACHINE
- rigid steel frame construction
- 2 workpiece clamping devices with integrated
stop system
- Separate adjustment of the clamping devices
via rack and pinion gear in X-direction
- Digital AC servomotors
- The position of the clamping devices
at the workpiece is program-controlled
- Adjustment of the clamping devices between
the separate processing steps in the
processing area is possible.
- Automatic measuring of the workpiece
thickness and lengths by the clamps and the
stop system
- Blowing nozzle for safe removal of residual
parts off the clamps
1.1 LOWER PROCESSING SUPPORT
- Rigid aluminium cast construction
- Integrated threefold divided table
with selectable air cushion
- Lateral stop system
- Adjustment of the axes in Y- and Z-direction
- Ball bearing spindle (Z-direction) and
rack and pinion gear (Y-direction)
- Digital AC servomotors
- Suitable for fitting of various
configurations
1.2 UPPER PROCESSING SUPPORT
- Rigid aluminium cast construction
- Integrated threefold divided pressure beam
with selectable air cushion
- Adjustment of the axes in Y- and Z-direction
- Ball bearing spindle (Z-direction) and
rack and pinion gear (Y-direction)
- Digital AC servomotors
- Suitable for fitting of various
configurations
1.3 WORKPIECE DIMENSIONS
workpiece length: min. 200 mm
workpiece length: max. 2500 mm
workpiece width: min. 70 mm
workpiece width: max. 1000 mm
- with restrictions
in processing: 1300 mm
workpiece thickness: min. 8 mm (2 x 4 mm)
workpiece thickness: max. 80 mm (2 x 40mm)
workpiece stacking: max. 2 pieces
- same workpiece dimensions
Note:
- Workpieces must have a straight edge at the
reference edge
- Max. curve tolerance: +/- 0.5 mm for a work-
piece length = 2000 mm
- The workpiece length/width ratio should
be >=1. The longer edge of the workpiece
should be placed on the machine.
- Warped workpieces (>= 0.3 mm) lead to a
higher rate of processing tolerances and wear
at the workpiece tables
- Due to the chips no stackable workpieces can
be guaranteed for router processings.
- An external cleaning or extraction in the
outfeed area is recommended.
- For through holes of double parts the
Dcjdpjz Df Txsfx Afmjp
drilling quality depends on the workpiece
material and the tool as well as on the
feeding speed profile and the rotation speed
of the drilling spindle. Thus, however,
efficiency could possibly be reduced.
1.4 WORKPIECE FEEDING AREA
- Air cushion table in rigid frame
construction
- Surface from Hornit board
- integrated fan
1.5 WORKPIECE REMOVAL AREA
- Cross belt conveyor in rigid frame
construction
- 8 transport belts, frequency-controlled
drive
- 8 electro-pneumatic controlled disengaging
device
2. CE SAFETY AND PROTECTION DEVICES
- Safety fences in the lateral and rear area
- Safety mats in the feeding area
3. ENVIRONMENTAL CONDITIONS
- prescribed environmental temperature:
+ 5 degrees up to + 40° C
(in case of environmental temperature >35°C
or air humidity >65% a cooling unit for
switch cabinet is recommended)
4. ENERGY SAVING MODE
- ecoPlus button for starting stand-by
operation. The button can be activated during
processing. This will have the following
impacts after the end of the program:
- Primary power of drives will be switched